Galmet SGW(S) Maxi 300 Installation And Operating Manual - Page 5

Browse online or download pdf Installation And Operating Manual for Water Heater Galmet SGW(S) Maxi 300. Galmet SGW(S) Maxi 300 20 pages.

Print Page

4. Titanium, maintenance-free, active anode

- reliable, durable protection

- low consumption of anodes

- no sludge on the anode

- not required regeneration

- guaranteed long-term operation of the tank

1. Titanium anode

2. Potentiostat (AC)

3. Grounded cord

NOTE ! Before installing the anode CORREX, remove existing protective magnesium anode.

1. Cable supplied bipolar, connecting the anode CORREX and potentiometer plug must not be lengthened.

2. A random change in polarity causes the acceleration of corrosion.

3. It is recommended to use the socket 230 V in a short distance from the tank.

LED CONTROL

ON - green colour

OFF

ON - red colour

4. Titanium, maintenance-free, active anode

CAUSE

- Anode CORREX working properly. Full

protection against corrosion.

- Lack of electricity.

- Lack of water in the tank.

- Cables between the electronic part and the

anode is connected incorrectly.

- Lack of contact between the ground (tank)

and the electrical part of the anode.

- The anode is contacted with the mass of

the tank.

Installation and Operating Manual / Warranty Card - SGW(S): Maxi / Maxi Plus / M

METHOD OF REMOVAL

- Check the voltage 230 V.

- Fill the tank with water.

- Put the cables at the anode.

- Check and clean the rust all connections.

- Properly isolate the anode from the tank.