CORA CS1040 User Manual - Page 5

Browse online or download pdf User Manual for Accessories CORA CS1040. CORA CS1040 20 pages. Long range tilt & vibration sensor

Print Page
CORA CS1040 User Manual
User
Interface

Set Button

The CS1040 user interface consists of the LED status indicators (Figure 2) and the set button
located on the underside of the device. Pressing the button quickly will send a battery health
message and indicate the current network status discussed previously.
Figure 3 – Performing Network or Factory Reset on the Vibration Sensor
Holding the button will perform a network or factory reset:
⧫
Network Reset
release. The device will reset all LoRaWAN Settings, which does not affect device
operation or configuration. Following reboot, a reset event uplink (confirmed) will be
sent upon rejoining the LoRaWAN network.
⧫
Factory Reset
device will reset all parameters to factory defaults. Following reboot, a Factory Reset
event uplink (confirmed) will be sent upon rejoining the LoRaWAN network.

Status Indicators

A single button press will indicate the network status. The following table summarizes all the
LED indicators.
LED
Fast Red Blink Two (2) Times
Fast Green Blink Four (4) Times
Slow Red Blink Two (2) Times
Slow Green Blink Four (4) Times
CS1010 Long Range Vibration Sensor – User Guide
– Press and hold the SET button for 10 seconds, but less than 25, then
– Press and hold the SET button for > 25 seconds, then release. The
Status
Not Joined
Joined
Joining Network
Joined Network
Page 5