CORA CS1040 User Manual - Page 6

Browse online or download pdf User Manual for Accessories CORA CS1040. CORA CS1040 20 pages. Long range tilt & vibration sensor

Print Page

Network status blink occurs up to 50 times. Single button press will resume status blink for

another 50 cycles.

Selecting Operating Configuration

The CS1040 can be configured through a series of button presses to operate in one of the

available default settings. Select one of the following settings based on the application

requirements.

Default

Configuration

Vibration Impulse

Detector

(Default)

Garage Door Tilt

Detector

Continuous

Vibration Sensor

To change the Sensor configuration:

Press the button slowly three (3) times (about 2 – 3 presses per second max) to enter

the configuration selection mode. The device will alternate green/red blink pattern

continuously once entered.

Then press the button slowly the corresponding number of times (e.g., 1,2, or 3) to

select the desired configuration.

If pressed more than four (4) times, the selection will be cleared and a new selection

specified. If no selection is made in 30 seconds, the device will exit configuration mode

without changes.

Once the choice of configuration is made, the device will stop the blink pattern, wait 30

seconds for no further input, apply the configuration change, and perform a network

reset.

CS1010 Long Range Vibration Sensor – User Guide

Description

Sends notification whenever a vibration or rotation is

detected. Waits three minutes to clear between additional

notifications. Battery health check sent once per day. This

configuration is good to monitor any movement such as

breaking glass, package tampering, opening a drawer, or

safe.

The device ships with this configuration as the default.

Battery life is typically 2+ years.

Monitors vibration and vertical rotation when attached to a

garage door. Sends notifications when opening, closing,

and hourly reminders when not closed. Battery health

check sent once per day.

Battery life is typically 2+ years.

Monitors continuous vibration or rotation. Sends

notification when motion begins and ends. Battery health

check sent once per day.

This configuration is useful for monitoring the use of

mechanical equipment. Battery life is typically 2+ years.

Button

Presses

Page 6