hikam S6 Quick Start Manual - Page 5

Browse online or download pdf Quick Start Manual for Security Camera hikam S6. hikam S6 13 pages. The camera for secure home

Print Page

Error diagnostics:

LED indicators

Blink

OFF

Please check the following conditions in the router in case of failure:

- Power off the router, wait for 30 seconds, power on the router and wait until the router is online

- Turn off the 5GHz WiFi signal in the router

- Use security mode: WPA2-TKIP or WPA2-PSK/AES

- In case "guest access" is used: disable the option: 'guest access' and enable the option: 'the devices are allowed to

communicate with each other'

- Set WiFi channel selection to 'automatic'

Launch using 'AP mode'

If during the 'AirLink' setup, the camera does not emit the confirmation sound ('dong...'), please try 'AP mode'. The

instructions for 'AP mode' can be found on the second page.

Installation manual

- Hold mounting plate with one hand and turn the white frame counter-clockwise to open / clockwise to close

- For vertical installation, set the mark pointing upwards

- The RESET button is located on the back of the camera

Picture 7

Support:

http://support.hi-kam.com

For further instructions, video tutorials, software, data sheets, specs, FAQs.

Guaranteed feedback within 24hrs, often within 4hrs.

Status

Power up

OFF

AirLink

Blink

AP mode

The camera is connected to the router via WiFi. This status

OFF

LED can be switched off in HiKam app

Wrong WiFi password. Please reset the camera and launch it

Blink

again

WiFi signal strength weak. Please move the camera closer to

the router.

Receipt of an IP address failed. In the router settings, please

Blink

enable DHCP and disable MAC filter.

Picture 8

(picture 9).

Picture 9

7, 8

(pictures