hikam S6 Посібник із швидкого старту - Сторінка 5
Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Камера спостереження hikam S6. hikam S6 13 сторінок. The camera for secure home
Друкувати сторінку
Error diagnostics:
LED indicators
ON
Blink
Blink
ON
OFF
OFF
ON
Please check the following conditions in the router in case of failure:
- Power off the router, wait for 30 seconds, power on the router and wait until the router is online
- Turn off the 5GHz WiFi signal in the router
- Use security mode: WPA2-TKIP or WPA2-PSK/AES
- In case "guest access" is used: disable the option: 'guest access' and enable the option: 'the devices are allowed to
communicate with each other'
- Set WiFi channel selection to 'automatic'
Launch using 'AP mode'
If during the 'AirLink' setup, the camera does not emit the confirmation sound ('dong...'), please try 'AP mode'. The
instructions for 'AP mode' can be found on the second page.
Installation manual
- Hold mounting plate with one hand and turn the white frame counter-clockwise to open / clockwise to close
- For vertical installation, set the mark pointing upwards
- The RESET button is located on the back of the camera
Picture 7
Support:
http://support.hi-kam.com
For further instructions, video tutorials, software, data sheets, specs, FAQs.
Guaranteed feedback within 24hrs, often within 4hrs.
Status
ON
Power up
OFF
AirLink
Blink
AP mode
The camera is connected to the router via WiFi. This status
OFF
LED can be switched off in HiKam app
Wrong WiFi password. Please reset the camera and launch it
Blink
again
WiFi signal strength weak. Please move the camera closer to
ON
the router.
Receipt of an IP address failed. In the router settings, please
Blink
enable DHCP and disable MAC filter.
Picture 8
(picture 9).
(picture 9).
Picture 9
7, 8
(pictures
).