AGS Merlin TFT Installation & Operation Manual - Page 10
Browse online or download pdf Installation & Operation Manual for Gas Detectors AGS Merlin TFT. AGS Merlin TFT 16 pages.
Print Page
Installation & Operation Manual
OPERATION
First Power Up
On connecting power, the detector enters 'sensor stabilisation' phase for approximately 60
seconds – during this period the screen will display an 'initialisation' message
indicating that the device is not yet ready for gas detection.
When the sensor has stabilised – the screen will display;
a.
the relevant gas type intended to be detected
b.
detected gas level in the area
c.
the measurement value
d.
the detector unique serial number
e.
the detector ID number
Gas Level Indicators
SAFE
Safe gas levels will be
displayed GREEN.
At dangerous gas levels, the alarm will continuously sound if the buzzer dip-switch is ON.
Only when gas levels are at a safe level will the audible alarm stop.
End of Life Indicator
This message indicates that the detector has reached its expected operational lifecycle.
No gas levels will be displayed. Contact your supplier and replace the unit immediately.
AGSDETTFT-IOM Iss: 5 06-20
ATTENTION!
Low gas levels will be
displayed YELLOW.
There are no provisions to silence this alarm.
The expected lifecycle will depend on the type of gas your detector is
targeting and may vary depending on environmental conditions.
Merlin Gas Detector TFT
DANGER!
Dangerous gas levels
will be displayed RED.
10