aireRyder F0069 Manual - Page 6

Browse online or download pdf Manual for Fan aireRyder F0069. aireRyder F0069 9 pages.

Print Page
Fig.8
Hanger Bracket
Slot
Chip
Hang the fan on Hanger Bracket, and
make sure the slot of hanger ball is
snapped into the chip of Hanger
Bracket exactly.
Note: For slope ceiling installation,
make sure the slot of hanger ball and
the chip of hanger bracket face down.
Fig.10
Antenna
a.
c.
Move Ground Wires (a), Outlet Box wires (b), and
Motor Wires (c) away from the center of the Hanger
Bracket. Then slide Receiver through Hanger
Bracket as shown, Antenna end first, until it is
centered. Finally, cut Motor Wires (c) to length
needed for connections.
Hang the safety cable into the safety cable hook.
Receiver
DIP Switch
Fig.9
There is a code switch in the transmitter
and receiver. This "DIP Switch" is a 4 key
unit (Fig.9). All keys were set at "ON"
position in the beginning. Set the keys to
a different code. Make sure the same
numbered keys are switched "ON" for
both DIP Switches (Fig.9a). Take note
that the "ON" position may have different
orientation in each.
Receiver
b.
Hanger Bracket
Fig.12
Antenna
Transmitter
Fig.11
6.
Antenna:
DO NOT CUT
OR SPLICE
Make wire connections:
1) The Motor white wire to the white "To Motor N" wire from
Receiver with a wire connector.
2) The Motor black wire to the black "To Motor L" wire from
Receiver with a wire connector.
3) The Motor blue wire to the blue "For Light" wire from
Receiver with a wire connector.
4) The white wire from Outlet Box to the white "AC in N" wire
from Receiver with a wire connector.
5) The black (hot) wire from Outlet Box to the black "AC in L" wire
from Receiver with a wire connector.
6) The ground wire from Outlet Box to the green ground wire
from the Hanger Ball and the green ground wire from the
Hanger Bracket with a wire connector.
Make sure all of wire connectors are connected firmly.
*** Tuck all wire connectors and wires carefully up into the
Outlet Box.
PAGE: 6 / 9
Code example:
1-ON 2-OFF 3-ON 4-OFF on both DIP
Switches.
Note: If you have two ceiling fans
with 2 remote control units, set 2
different codes for each set of
transmitter / receivers.
3.
2.
1.
Receiver
F
A
4.
5.
Hanger
Bracket
Hanger
Ball
N
C
O
200116