aireRyder FN44444 Instructions For Installation And Use Manual - Page 5

Browse online or download pdf Instructions For Installation And Use Manual for Fan aireRyder FN44444. aireRyder FN44444 6 pages.

Print Page

Suction Cup

Bulb GU10 Max.50W

(Excluded)

Reverse

Slide Switch

Forward

Fan Light Pull

Chain

Fig.16-a

Install two pull chains and drops onto the pull chains located in the switch box and light kit.

The pull chain controls the fan speed as follows:

1 pull – High, 2 pulls – Medium, 3 pulls – Low, and 4 pulls – Off.

To turn the light kit "ON" or "OFF", pull the chain that is attached to the light kit.

Caution: If you install a remote control or a wall control for this fan, pull the pull chains to "high speed" of the

fan motor and "on" of the fan light.

Fig.17

161031

Install bulbs (Excluded).

a. Attach the suction cup to the surface of the halogen bulb lens.

b. Insert and twist the bulb (GU10 MR16C BULB ONLY) into the socket by

using the suction cup.

c. Remove the cup from the halogen bulb lens by pulling the knob of the suction

cup.

d. Repeat with other bulbs.

Do not discard the suction cup, it will be needed when replacing the bulb.

Adjust the spotlight head to a desired position by using the swivel.

Caution: Turn off the electric circuit and allow the fixture to cool down

Fig.15

completely before replacing the bulbs.

Switch Box

Fan Speed Pull

Chain

Install pull

chains and

drops

Turn on the electric circuit at the main fuse

or circuit breaker box.

The slide switch on the switch box sets the direction of fan rotation.

Select the desired direction of fan rotation. Push the slide switch

down for " Forward" and up for "Reverse".

Note: Wait for fan to stop before reversing the direction of blade

rotation.

Reverse

Slide Switch

Forward

Fig.16-b