AGT INDUSTRIAL AGT-RC72 Product Manual - Page 9

Browse online or download pdf Product Manual for Brush Cutter AGT INDUSTRIAL AGT-RC72. AGT INDUSTRIAL AGT-RC72 19 pages. Skid steer brush cutter

Print Page

Installation

Unpack and check

Check for missing or damaged components according to the packing list.

If you have any questions, please contact the supplier. List of details As the table above:

Equipment must be installed on a solid concrete floor or similar. If the ground is not

firm, it will not be able to connect to the loader. There should be a space around the

device for easy operation.

Connecting Brush Cutter

Consult your skid steer operator's manual for specific instructions on how to

connect your brush cutter to your skid steer loader.

General Attachment Method

1. Make sure the hydraulic lines are clear from the front side of the brush cutter's

attachment plate and that the locking pins on the skid steer mounting plate are

retracted.

2. Drive forward and place top of skid steer mounting plate underthe attachment

mounting flange. See Figure 3.3 below.

3. Slowly raise and tilt back the skid steer mounting plate untilthe brush cutter

attachment plate rests flat against the skid steer mounting plate.

4. Activate your skid steer's lever lock switch to engage and lock the pins into the

flange slots of the brush cutter's attachment plate. If your skid steer does not have

this switch, push the latch handles down until you can see the lock pins extend into

the attachment flange.

5. Connect the attachment hydraulic hoses and the case drain hose (SBCNS model

only) to the auxiliary supply couplers located on your skid steer loader lift arm.

Skid Steer Mounting Plate to Attachment Mounting Flange