AGT INDUSTRIAL AGT-RC72 Manual do produto - Página 9
Procurar online ou descarregar pdf Manual do produto para Cortador de escova AGT INDUSTRIAL AGT-RC72. AGT INDUSTRIAL AGT-RC72 19 páginas. Skid steer brush cutter
Imprimir páginaInstallation
Unpack and check
Check for missing or damaged components according to the packing list.
If you have any questions, please contact the supplier. List of details As the table above:
Machine installation
Equipment must be installed on a solid concrete floor or similar. If the ground is not
firm, it will not be able to connect to the loader. There should be a space around the
device for easy operation.
Connecting Brush Cutter
Consult your skid steer operator's manual for specific instructions on how to
connect your brush cutter to your skid steer loader.
General Attachment Method
1. Make sure the hydraulic lines are clear from the front side of the brush cutter's
attachment plate and that the locking pins on the skid steer mounting plate are
retracted.
2. Drive forward and place top of skid steer mounting plate underthe attachment
mounting flange. See Figure 3.3 below.
3. Slowly raise and tilt back the skid steer mounting plate untilthe brush cutter
attachment plate rests flat against the skid steer mounting plate.
4. Activate your skid steer's lever lock switch to engage and lock the pins into the
flange slots of the brush cutter's attachment plate. If your skid steer does not have
this switch, push the latch handles down until you can see the lock pins extend into
the attachment flange.
5. Connect the attachment hydraulic hoses and the case drain hose (SBCNS model
only) to the auxiliary supply couplers located on your skid steer loader lift arm.
Skid Steer Mounting Plate to Attachment Mounting Flange