Majestic 5.0 Octave Quantum Marimba Assembly Instruction - Page 2

Browse online or download pdf Assembly Instruction for Musical Instrument Majestic 5.0 Octave Quantum Marimba. Majestic 5.0 Octave Quantum Marimba 2 pages.

Print Page

III. Set up Resonators

● Attach resonators

Resonators are setup under the frame. Pick up one

resonator, make sure suspension arms is at open

position; attach resonator set by seating arms firmly

into notches on side frame & rails.

For 4.3 Oct Model

For 5.0 Oct Model

V. Other adjustments

● Instrument height

Hold frame end with one hand, using the other hand

to loosen the knob to raise or lower the keyboard

height as needed. Tighten the knob after adjustment.

Adjust one end at a time, using scale guide to level

instrument. Do not exceed 2" increments at a time.

● Connect stabilizer bracket

For better resonator stability, you can find stabilizer

arms locate on the rail side.

Pull up the arms, swing over resonator top and insert

to corresponding rubber notch. Press down to

complete the assembly.

For 4.3 Oct Model

For 5.0 Oct Model

P11

● Tone bar leveling

Due to the resonator weight, the rail might sag in the

middle after resonators are attached. This can be

corrected by extension screw length located inside

hinged center.

IV. Place Toner bars

● Unroll the bars

Carefully unroll the tone bars on the flat floor, flip the

bars over so that the playing side faces up (arch side

faces down). Keep out the springs and sharp

object away from tone bar. Prevent scratch or

damages to bar surface.

Use soft wrapping to protect bars, do not scratch.

P12

VI. Other parts

● Front speaker post

Working from the audience side of instrument, place

speaker post on the wheel deck located on treble end

leg assembly. Attach the speaker post to frame with

T-Clamp (AQ11/RU8Q).

● Front accessory bar

Working from the audience side of instrument, use

T-Clamps to attach front accessory bar to the speaker

post at the treble end, and directly onto the leg

assembly at the bass end. (as shown on the photo)

● Position tone bars

Place the Natural note bars on top of the lower rails

(close to player side).

Position each tone bar in between bar posts, begin

from treble end, working progressively down towards

bass end.

Repeat above process with accidentals (refer to C

chromatic scale), placing tone bars over capped

resonators only. Open resonators should have no bar.

● Fasten Cord & spring

Once tone bars are in place, pull excess bar cord

through bass end, bring bar cord around end posts

and hook the springs together.

The springs has a small tension after they are

booked. You can adjust knot on the cord to get

different tensions after springs are connected.

P13

VI. Finished View

M1543P

M1550P

P10

P14