Majestic 5.0 Octave Quantum Marimba Instruções de montagem - Página 2

Procurar online ou descarregar pdf Instruções de montagem para Instrumento musical Majestic 5.0 Octave Quantum Marimba. Majestic 5.0 Octave Quantum Marimba 2 páginas.

III. Set up Resonators
● Attach resonators
Resonators are setup under the frame. Pick up one
resonator, make sure suspension arms is at open
position; attach resonator set by seating arms firmly
into notches on side frame & rails.
For 4.3 Oct Model
For 5.0 Oct Model
V. Other adjustments
● Instrument height
Hold frame end with one hand, using the other hand
to loosen the knob to raise or lower the keyboard
height as needed. Tighten the knob after adjustment.
Adjust one end at a time, using scale guide to level
instrument. Do not exceed 2" increments at a time.
P7
● Connect stabilizer bracket
For better resonator stability, you can find stabilizer
arms locate on the rail side.
Pull up the arms, swing over resonator top and insert
to corresponding rubber notch. Press down to
complete the assembly.
For 4.3 Oct Model
For 5.0 Oct Model
P11
● Tone bar leveling
Due to the resonator weight, the rail might sag in the
middle after resonators are attached. This can be
corrected by extension screw length located inside
hinged center.
P8
IV. Place Toner bars
● Unroll the bars
Carefully unroll the tone bars on the flat floor, flip the
bars over so that the playing side faces up (arch side
faces down). Keep out the springs and sharp
object away from tone bar. Prevent scratch or
damages to bar surface.
Use soft wrapping to protect bars, do not scratch.
P12
VI. Other parts
● Front speaker post
Working from the audience side of instrument, place
speaker post on the wheel deck located on treble end
leg assembly. Attach the speaker post to frame with
T-Clamp (AQ11/RU8Q).
● Front accessory bar
Working from the audience side of instrument, use
T-Clamps to attach front accessory bar to the speaker
post at the treble end, and directly onto the leg
assembly at the bass end. (as shown on the photo)
P9
● Position tone bars
Place the Natural note bars on top of the lower rails
(close to player side).
Position each tone bar in between bar posts, begin
from treble end, working progressively down towards
bass end.
Repeat above process with accidentals (refer to C
chromatic scale), placing tone bars over capped
resonators only. Open resonators should have no bar.
● Fasten Cord & spring
Once tone bars are in place, pull excess bar cord
through bass end, bring bar cord around end posts
and hook the springs together.
The springs has a small tension after they are
booked. You can adjust knot on the cord to get
different tensions after springs are connected.
P13
VI. Finished View
M1543P
M1550P
P10
P14