IKEA ENHET Installation Manual - Page 10

Browse online or download pdf Installation Manual for Indoor Furnishing IKEA ENHET. IKEA ENHET 16 pages. Kitchen
Also for IKEA ENHET: Installation Manual (10 pages), Installation Manual (20 pages)

Print Page

Installing the benchtop

Clean the raw edges of the cut-out/s and lightly sand

them. Then apply silicone to prevent moisture from

penetrating the benchtop. Let the silicone dry before

you install the sink and/or cooktop.

Installing the sink and tap

Before you start to install the kitchen mixer tap,

double-check that the connections between the

water supply and the tap fit. Then switch off the main

shut-off valve. Keep in mind that the installation

must be performed in compliance with current local

construction and plumbing regulations. If in doubt,

contact a professional.

Before sliding the sink into position, follow the

assembly instructions of the sink and attach the

clamps that come with it. Once in position, adjust

the clamps in order to secure the sink.

Next, connect your water trap and tap to complete

the sink and tap installation.

Corners can be tricky so take your time and adjust

both pieces until they are perfectly aligned and level.

For small adjustments, use the adjustable feet, or

shim between the cabinet and the benchtop.

While some of our sinks come with a pre-cut hole for

the tap, there are cases where you need to install the

tap on the benchtop. In this case, make sure you use

a drill that is powerful enough to drill through the

benchtop material.

If you need to install the tap on the benchtop, see the

assembly instructions of the tap for the dimension

of the hole. Once you've marked the position of the

hole, check that it doesn't collide with the top rail of

the cabinet underneath. After you've drilled the hole,

clean and seal the hole with silicone.

Once the benchtop pieces are level and align with

the wall, fix the benchtop to the cabinets and apply

silicone in order to prevent fluids from penetrating

the surface.

Once the sink and tap are in place and secured,

seal the edges around them with silicone to create

a watertight seal.