Majestic Appliances MJ-9200D Owner's Manual - Page 7

Browse online or download pdf Owner's Manual for Dryer Majestic Appliances MJ-9200D. Majestic Appliances MJ-9200D 16 pages. Vented separate/stacking dryer
Also for Majestic Appliances MJ-9200D: Owner's Manual (15 pages)

Print Page

Bnsta|ling/Removin

Gettin

things

ready

appliance

(co

Alternate

Installations

install

your

Stacking

Installations

• When installing the appliance in a configuration where washers and dryers are stacked vertically, there are several

methods that have proven successful

Clearance

Considerations

Option I - 3 inch clearance all around the machine Which allows for adequate air flow for the dryer

Option 2 - If zero clearance on the sides then installer must allow for a minimum of t inch at the rear of the unit

and a minimum of 1 inch clear space on the top of the dryer to allow for air movement to the back of the dryer

addition, in an enciosed installation installer must provide a air intake area of no less than t2 sq in of un_obstructed

free air space through the door, around the units to the back of the dryer to allow for adequate air intake

Otherwise

installer must apply a label that instructs the user that the dryer cannot be operated with the door closed

Duct hose length:

A maximum of 12 inches of 4 inch flex hose can be used to vent the dryer

Electrical Hookups: Each machine must have it's own 15 amp circuit in order to run the Washer and Dryer

simultaneously

Stacking

Installation:

Option t - Although we recommend the use of the Majestic Stacking

Brackets (Model 17-I057) alternative mounting bracketry may be used if bracket configuration

is approved by Majestic Appliances

instructions are included with the mounting brackets

as to their application

Majestic brackets ensure that no wiring or hoses are impacted by the

installation

Option 2 _Mount the dryer on its own shelf, utilizing the same guidelines as if it were mounted

on a floor (See page 6)

tf you have any other unique needs do not hesitate to call us on our toll-free number and we wi!t

assist you

CORRECT

LEVELING

OF UNIT IS ESSENTIAL

It is important for the machine to be perfectly level The angle of

inclination on the work surface must not be more than 2 degrees

For this reason the machine is fitted with adjustable feet used for

leveling the machine before use In the case of carpeted flooring,

remember to check that the ventilation in the support area is not

plugged

Exhaust

Duct Installation

• Check that all ducting is lint free, clean with duct tape to secure atl joints A maximum

of 12 inches of 4 inch flex hose can be used to vent the dryer

• The exhaust duct must end with an approved exhaust vent hood with swing out

dampers or appropriate louvers

• Flex or rigid metallic ducting is recommended

. Exhaust duct should be short and straight and slope downwards and away from

the appliance

Long exhaust duct runs can increase drying time, collect tint and may

increase drying times

IMPORTANT!

THE EXHAUST DUCT SHOULD NOT BE

INSERTED

INTO A CHIMNEY, WALL , CEILING OR CONCEALED

SPACE OF

STRUCTURE

Page

@2003Manufacturers Supply. Inc

__==

/J I