AFRISO DIM 20 Instruction Manual - Page 15
Browse online or download pdf Instruction Manual for Measuring Instruments AFRISO DIM 20. AFRISO DIM 20 20 pages. Digital pressure gauge
Print Page
UPPER
DECIMA
UNIT
SW OFF
DIM 20
Menu 2: Indicate maximum measuring range
Call up menu point "UPPER".
The maximum measuring range is shown in the upper display line.
This value was chosen at the time of ordering and cannot be
changed.
Menu 3: Changing the position of the decimal point
1.
Call up menu point "DECIMA".
2.
Press OK.
"DECIMA" starts to blink.
3.
Use
or
4.
Press OK to confirm the selection.
Attention: Depending on pressure range and selected unit of meas-
urement only a limited number of decimal points may be possible.
Menu 4: Changing the pressure unit
1.
Call up menu point "UNIT".
2.
Press OK.
The currently adjusted unit starts to blink.
3.
Use
or
bar, mbar, PSI, InHg, cmHg, mmHg, hPa, kPa, Mpa or mWs.
4.
Press OK to confirm the selection.
Attention: When changing the unit it may also be necessary to
change the decimal point so that the actually present pressure can
continue to be displayed correctly. Depending on the pressure range,
it is possible that not all of the units can be used.
Menu 5: Changing the automatic switch-off
1.
Call up menu point "SW OFF".
2.
Press OK.
"SW OFF" starts to blink.
3.
Use
or
Figures 0 to 5 are available. With figure 0 the automatic switch-
off is disabled. With figures 1 to 5 the automatic switch-off time
is determined in number of minutes.
4.
Press OK to confirm the selection.
to select the required position of the decimal point.
to select the required unit:
to select the required figure:
Operation
15