Gamma 5003 Owner's Manual - Page 7
Browse online or download pdf Owner's Manual for Stringing Machines Gamma 5003. Gamma 5003 20 pages. 6 point mounting
Also for Gamma 5003: Owner's Manual (20 pages), Owner's Manual (19 pages), Owner's Manual (20 pages)
ASSEMBLY INSTRUCTIONS
Turntable and Mounting System
Installation
To install the turntable remove the four nuts
holding the mounting bolts in place during
shipment. Position the turntable over the
turntable pin and align the bolts with the
holes in the flange. Secure them with the
included allen wrench.
Caution: If the mounting bolts are removed
or fall out during assembly be sure that the
bolts pass through the spacer inside the
turntable before securing the turntable to
the turntable pin.
String Clamp Installation
The post of the string clamp and tube of the
string clamp base are treated with grease to
provide protection against corrosion during
shipping. Remove any excessive grease with
a clean cloth prior to use. The post and tube
may also be cleaned with isopropyl alcohol.
After this type of thorough cleaning, the post
and tube should be treated with a light coating
of machine oil to protect the surfaces against
corrosion and to ensure smooth operation.
Installing the Tensioner
Remove the button head screw and washer
located at the end of the tensioner bar with
the 3mm hex wrench provided. Slide the
tensioner onto the bar, being careful to align
the bar with all of the bearings and the drive
gear with the gear track. Replace the button
head screw and washer in the end of the
tensioner bar.
7