Gamma 6004 Owner's Manual - Page 13

Browse online or download pdf Owner's Manual for Stringing Machines Gamma 6004. Gamma 6004 19 pages. 6 point mounting
Also for Gamma 6004: Owner's Manual (20 pages), Owner's Manual (20 pages), Owner's Manual (20 pages)

Print Page

MAINTENANCE & ADJUSTMENTS

Tension Calibration Procedure

Step 1

Set the tension to 60 lbs. as indicated by the

linear scale and rotary knob. Place the string

on one end of a tension calibrator into a

string clamp and secure. Place string lo-

cated on the other end of the calibrator into

the string tensioner and apply tension. If the

brake lever releases before 60 lbs. or after

60 lbs., the tension head should be cali-

brated as follows.

Step 2

Loosen the 1.5 mm locking set screw (A)

located on the side of the latching block as

shown. The set screw is used to hold the

adjustment screw in place.

Step 3

If the lever releases before 60 lbs., using the

supplied L-shaped hex wrench, turn the

adjustment screw (B) located on the left side

of the latch block counter-clockwise to in-

crease the engagement of the brake release

latch with the brake lever. Repeat step 1 and

adjust until the correct tension is indicated

on the calibrator.

If the tension indicated in step 1 is greater

than 60 lbs., turn the adjustment screw

clockwise to reduce the engagement of the

brake release latch with the brake lever.

Repeat step 1 and adjust until the correct

tension is indicated on the calibrator.