Gamma X-ES Owner's Manual - Page 6

Browse online or download pdf Owner's Manual for Stringing Machines Gamma X-ES. Gamma X-ES 19 pages.

Print Page

POWER CONNECTION & CONTROLS

Instructions for Power Connection and Controls

CAUTION ! Before connecting to the power supply, check the voltage supply switch

located on the back side of the tensioner. To change from 110 to 220 volt service

slide the switch fully to the left or to the right until "115V" or "230V" appears on the

switch plate.

The acceptable range of input voltages for the "115 V" setting is between 110 V and 120 V

@ 60 Hz and for the "230 V" setting, between 220 V and 240 V @ 50 to 60 Hz. If you have

any question regarding the input voltage supply for your area, please ask your electric

utility company. When using extension cords, use grounded heavy duty extension cords

rated for 15 AMP service.

To install the power cord, insert the female end of the power cord into the Power Cord

Socket located on the rear panel (letter C). T o connect the foot pedal switch, insert the 2

pin male connector located at the end of the foot pedal switch cord into the two pin

receptacle located on the back pa nel. Tighten the connector with the sleeve nut located on

the foot pedal switch connector .

After checking to be certain that the machine is set for the correct input volt age, switch on

the machine by pressing the Lighted On-Off Power Switch on the rear p anel.

WARNING!

BY ADULTS OR UNDER ADULT SUPERVISION ONLY .

NEVER OPEN UNIT WITH POWER CONNECTED

FOR INDOOR USE ONLY . TO BE USED

Front Panel Features

A - String Gripper

B - Tension Switch

C - L.E.D. Tension Display

D - Tension Adjustment Knob

E - Calibration Screw Cover Plate

F - Gripper Reversing Switch

Side Panel Features

A -

Lighted Power Switch

To turn the power on, press the left

side of the switch.

B -

5 Amp Fuse Holder (w/ spare fuse)

C -

A/C Power Cord Socket

D -

2 Pin Foot Pedal Switch Receptacle