Green Brook Phoenix ELLEDH2 Installation & Operating Instructions Manual

Browse online or download pdf Installation & Operating Instructions Manual for Lighting Equipment Green Brook Phoenix ELLEDH2. Green Brook Phoenix ELLEDH2 6 pages. Led 4 in 1 hanging sign light

Print Page

Installation & Operating Instructions

LED 4 in 1 Hanging Sign Light Model - ELLEDH2

This unit should be installed by a competent person and in accordance the current IET Wiring

Regulations. If in doubt consult a qualified electrician. Switch off mains supply before installation,

maintenance or replacing lamps.

This product must not be modified. Any modification will negate any Safety Mark Approvals and may

render the product unsafe. GreenBrook accepts no responsibility for modified products. This product

must be installed in accordance with these instructions.

This fitting should not be installed in close proximity to any external source of heat or covered with any

heat insulating material, air flow around the fitting should not be restricted. Note any minimum distances

to adjacent surfaces. This unit should be connected to the lighting supply circuit, or fused at a

maximum of 3A.

This unit is a maintained, self-contained LED edge-lit hanging exit sign emergency luminaire.

Follow these instructions carefully to ensure safe and reliable operation. Retain this leaflet for future

reference. The emergency luminaire should be connected to a stable and permanent mains supply of

the correct rated voltage and frequency as stated on the product specification label. This may be from

the lighting supply circuit, or fused at a maximum of 3A. To facilitate testing a switched fused spur box

can be included in the unswitched permanent live supply.

Class I. This product must be earthed.

All switching etc, shall comply with BS 5266 Part 1. Unless specifically permitted, emergency luminaires

should not be connected or controlled by any energy management device. Before commencing

installation, ensure that the electricity supply and battery pack are disconnected.

The Greenbrook ELLEDH2 sign can be mounted in a number of different ways and is supplied with the

brackets required for mounting. Diagrams 1 to 4 show the different methods of mounting this product.

All installations will require the main case to be opened.

To open the main casing, remove the screw from the end of the casing and release the clip at the

opposite end.

Supplied Brackets

Flagpole

Bracket

SAFETY

GENERAL DESCRIPTION

INSTALLATION INSTRUCTIONS

'Phoenix' Range

For

Recess Mounting

Bracket

Wall Mounting

Bracket