Green Brook Phoenix ELLEDH2 Руководство по установке и эксплуатации
Просмотреть онлайн или скачать pdf Руководство по установке и эксплуатации для Осветительное оборудование Green Brook Phoenix ELLEDH2. Green Brook Phoenix ELLEDH2 6 страниц. Led 4 in 1 hanging sign light
Печатать страницуInstallation & Operating Instructions
LED 4 in 1 Hanging Sign Light Model - ELLEDH2
This unit should be installed by a competent person and in accordance the current IET Wiring
Regulations. If in doubt consult a qualified electrician. Switch off mains supply before installation,
maintenance or replacing lamps.
This product must not be modified. Any modification will negate any Safety Mark Approvals and may
render the product unsafe. GreenBrook accepts no responsibility for modified products. This product
must be installed in accordance with these instructions.
This fitting should not be installed in close proximity to any external source of heat or covered with any
heat insulating material, air flow around the fitting should not be restricted. Note any minimum distances
to adjacent surfaces. This unit should be connected to the lighting supply circuit, or fused at a
maximum of 3A.
This unit is a maintained, self-contained LED edge-lit hanging exit sign emergency luminaire.
Follow these instructions carefully to ensure safe and reliable operation. Retain this leaflet for future
reference. The emergency luminaire should be connected to a stable and permanent mains supply of
the correct rated voltage and frequency as stated on the product specification label. This may be from
the lighting supply circuit, or fused at a maximum of 3A. To facilitate testing a switched fused spur box
can be included in the unswitched permanent live supply.
Class I. This product must be earthed.
All switching etc, shall comply with BS 5266 Part 1. Unless specifically permitted, emergency luminaires
should not be connected or controlled by any energy management device. Before commencing
installation, ensure that the electricity supply and battery pack are disconnected.
The Greenbrook ELLEDH2 sign can be mounted in a number of different ways and is supplied with the
brackets required for mounting. Diagrams 1 to 4 show the different methods of mounting this product.
All installations will require the main case to be opened.
To open the main casing, remove the screw from the end of the casing and release the clip at the
opposite end.
Supplied Brackets
Flagpole
Bracket
SAFETY
GENERAL DESCRIPTION
INSTALLATION INSTRUCTIONS
'Phoenix' Range
For
Recess Mounting
Bracket
Wall Mounting
Bracket