Jalousie-Welt Pergola PRO Operations And Maintenance, Instructions Of Shipment, Unpacking And Installation - Page 17

Browse online or download pdf Operations And Maintenance, Instructions Of Shipment, Unpacking And Installation for Accessories Jalousie-Welt Pergola PRO. Jalousie-Welt Pergola PRO 20 pages.

Print Page

Special bracket for the gutter system

3.8.7. Perform electrical installation (only for motor drive)

When laying the motor cable, make sure that no kinks or any sharp edges they can damage the cable. The

long-term operation of the awning with electric motor drive via electrical socket is not permitted! The

awnings switch should be mounted at a height of 125 cm over the ground in a location from which the user

sees the awning across its whole range of motion. The used switch must be designed by the manufacturer to

control awnings.

3.8.8. Set the end positions of the motor

After assembly of the awning, you should set the end position of the two directions, in accordance with the

instructions for the motor drive. The factory end position are set by manufacturer.

gutter

water pipe

concrete

C20/25

CAUTION!

The electrical connection must be performed by a licensed professional. Connect the

electrical wires according to the circuit diagram. The awning may only be connected if

the specifications on the type plate agrees with your power source.

CAUTION!

If worn or damaged cables, awning do not use until repaired by an authorized

technician.

pilar

special

bracket

page: 17 / 20