decoflame Montreal Installation Manual And User's Manual - Page 7

Browse online or download pdf Installation Manual And User's Manual for Indoor Fireplace decoflame Montreal. decoflame Montreal 10 pages. Custom-made bioethanol fireplaces
Also for decoflame Montreal: Installation Manual And User's Manual (12 pages)

Print Page

1. Operating Instructions

Filling of the Fuel Tank

– Re-fuelling during operation when FUEL LOW messages appears in the display

DO NOT

switch the electonics of the fireplace off. Push down onto the pop-up lid to the right. The display will

show the message FUEL LID OPEN and the fire will go into auto-shut-down mode. You will see the flames

disappear slowly.

DO NOT

start the re-fuelling process until you are certain that the fire is completely

extinguished. Then, open the fuel tank inlet by pulling the closing mechanism towards you. Insert a funnel

and fill in the bioethanol. Once the fuel tank is filled by three-quarters, you will hear an acoustic signal. This

tone will increase in line with the rising fuel level. Once the tank is completely filled, a constant tone will

sound. Stop the filling process. Avoid spillage during filling. If you spilled any bioethanol, use a paper kitchen

towel in order to wipe off thoroughly any spilled liquid around the fuel inlet. Remove the funnel. Close the

pop-up lid for the tank inlet. Flip over the pop-up lid with the LED-display to the left and reset the electronics

by switching the ON/OFF switch first into the OFF and then into the ON position.

NB: The ignition process will not start if any humidity is detected around the fuel inlet or if the pop-

up lid for the tank inlet is left open.

Ignition

Press the START button on the remote control or on the display (bottom right). The display will show the

message WARMING UP and the filament in the flame tray will start glowing.

After a short while, the first flames will show around the centre of the flame tray. Subsequently, It will take a

short time, until the whole width of the flame tray is filled with flames (depending on the dimensions of the

flame tray, it might take slightly longer). Once the flame tray shows flames throughout its complete width, the

fire will be burning at a pre-set level of 3 as long as the message WARMING UP is shown in the display –

this pre-set level cannot be changed. As soon as the warming-up phase is finished, the message FLAME 3

is shown in the display and the filament stops glowing.

Flame Regulation

Following the warming-up phase - as soon as FLAME 3 is shown in the display - the flame intensity can be

adjusted up- or downwards by pressing the number buttons on the remote control (1 is the lowest and 6 the

highest flame level) or the +/- buttons on the operating panel next to the LED-display.

Extinguishing the Flames

To switch off the fire at any time – also during the warming-up phase – press the STOP button on the remote

control or on the display (upper right). The flames will disappear within a few minutes. You can leave the

electronics on stand-by without pressing any further buttons now. You can also re-start the fire as described

above immediately. Or you could switch off the electronics completely.

Switching Off

In order to switch off the electronics of the fire completely, flip over the pop-up lid of the LED-display and

switch the child safety ON/OFF button into the OFF position.

Unintended Switching Off or Power-cut

Should you unintentionally switch off the electronics at the ON/OFF button or should you experience a

power-cut while the fire is still fully in operation the display will switch off, the remote control will no longer

work and the flames will disappear in a matter of minutes. You can start the fire again as described above

(and once electricity supplies are back to normal) whereby the warming-up phase will be shortened if the

flame tray is still warm from its earlier operation.