decoflame Montreal Руководство по установке и руководство пользователя - Страница 7
Просмотреть онлайн или скачать pdf Руководство по установке и руководство пользователя для Крытый камин decoflame Montreal. decoflame Montreal 10 страниц. Custom-made bioethanol fireplaces
Также для decoflame Montreal: Руководство по установке и руководство пользователя (12 страниц)
Печатать страницуFilling of the Fuel Tank
– Re-fuelling during operation when FUEL LOW messages appears in the display
DO NOT
switch the electonics of the fireplace off. Push down onto the pop-up lid to the right. The display will
show the message FUEL LID OPEN and the fire will go into auto-shut-down mode. You will see the flames
disappear slowly.
DO NOT
start the re-fuelling process until you are certain that the fire is completely
extinguished. Then, open the fuel tank inlet by pulling the closing mechanism towards you. Insert a funnel
and fill in the bioethanol. Once the fuel tank is filled by three-quarters, you will hear an acoustic signal. This
tone will increase in line with the rising fuel level. Once the tank is completely filled, a constant tone will
sound. Stop the filling process. Avoid spillage during filling. If you spilled any bioethanol, use a paper kitchen
towel in order to wipe off thoroughly any spilled liquid around the fuel inlet. Remove the funnel. Close the
pop-up lid for the tank inlet. Flip over the pop-up lid with the LED-display to the left and reset the electronics
by switching the ON/OFF switch first into the OFF and then into the ON position.
NB: The ignition process will not start if any humidity is detected around the fuel inlet or if the pop-
up lid for the tank inlet is left open.
Ignition
Press the START button on the remote control or on the display (bottom right). The display will show the
message WARMING UP and the filament in the flame tray will start glowing.
After a short while, the first flames will show around the centre of the flame tray. Subsequently, It will take a
short time, until the whole width of the flame tray is filled with flames (depending on the dimensions of the
flame tray, it might take slightly longer). Once the flame tray shows flames throughout its complete width, the
fire will be burning at a pre-set level of 3 as long as the message WARMING UP is shown in the display –
this pre-set level cannot be changed. As soon as the warming-up phase is finished, the message FLAME 3
is shown in the display and the filament stops glowing.
Flame Regulation
Following the warming-up phase - as soon as FLAME 3 is shown in the display - the flame intensity can be
adjusted up- or downwards by pressing the number buttons on the remote control (1 is the lowest and 6 the
highest flame level) or the +/- buttons on the operating panel next to the LED-display.
Extinguishing the Flames
To switch off the fire at any time – also during the warming-up phase – press the STOP button on the remote
control or on the display (upper right). The flames will disappear within a few minutes. You can leave the
electronics on stand-by without pressing any further buttons now. You can also re-start the fire as described
above immediately. Or you could switch off the electronics completely.
Switching Off
In order to switch off the electronics of the fire completely, flip over the pop-up lid of the LED-display and
switch the child safety ON/OFF button into the OFF position.
Unintended Switching Off or Power-cut
Should you unintentionally switch off the electronics at the ON/OFF button or should you experience a
power-cut while the fire is still fully in operation the display will switch off, the remote control will no longer
work and the flames will disappear in a matter of minutes. You can start the fire again as described above
(and once electricity supplies are back to normal) whereby the warming-up phase will be shortened if the
flame tray is still warm from its earlier operation.
7