IKEA SKALAN Instruction Manual - Page 16

Browse online or download pdf Instruction Manual for Hob IKEA SKALAN. IKEA SKALAN 24 pages.
Also for IKEA SKALAN: Manual (24 pages), Manual (48 pages)

Print Page

ENGLISH

marked on the identification plate. Refer to

the Technical data chapter.

The plug has to be fitted in a proper socket.

If connecting the appliance directly to the

electric system, it is necessary that you

install a double pole switch between the

appliance and the electricity supply, with a

minimum gap of 3 mm between the switch

contacts. The double pole has to be of a type

suitable for the required load in compliance

with the current rules.

The connection cable has to be placed in

order that, in each part, it cannot reach a

90 °C temperature. The blue neutral cable

must be connected to the terminal block

marked with "N". The brown or black phase

cable, fitted in the terminal block contact

marked with "L", must always be connected

to the live phase.

Electrical Requirements

You can check the parameters of

adjustment setting for this

appliance on the rating plate.

Refer to the Technical data

chapter.

The manufacturer declines any

liability if these safety measures

are not observed.

This hob is designed to be connected to a

220-240 V 50-60 Hz AC electrical supply.

Before switching on, make sure the

electricity supply voltage is the same as that

Gas connection

Warning! Refer to Safety

chapters.

Caution! Information for

authorised installer only.

indicated on the hob rating plate. The rating

plate is located below the surface of the

casing.

The hob is supplied with a 3 core flexible

supply cord.

Upon completion there must be no cut, or

stray strands of wire present and the cord

clamp must be secure over the outer sheath.

Replacement of the connection cable

Warning! To replace the

connection cable, the technician

must have a specific equipment.

In this case, only cable type H03V2V2-F T90

must be used. The cable section must be

suitable to the voltage and the working

temperature. The yellow and green earth

wire

must be approximately 2 cm longer

than the brown or black phase wire

Connection to main pipe

Warning! This appliance is not

connected to a combustion

products evacuation device.