IKEA SKALAN Gebruiksaanwijzing - Pagina 16

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} IKEA SKALAN. IKEA SKALAN 24 pagina's.
Ook voor IKEA SKALAN: Handmatig (24 pagina's), Handmatig (48 pagina's)

IKEA SKALAN Gebruiksaanwijzing
ENGLISH
marked on the identification plate. Refer to
the Technical data chapter.
The plug has to be fitted in a proper socket.
If connecting the appliance directly to the
electric system, it is necessary that you
install a double pole switch between the
appliance and the electricity supply, with a
minimum gap of 3 mm between the switch
contacts. The double pole has to be of a type
suitable for the required load in compliance
with the current rules.
The connection cable has to be placed in
order that, in each part, it cannot reach a
90 °C temperature. The blue neutral cable
must be connected to the terminal block
marked with "N". The brown or black phase
cable, fitted in the terminal block contact
marked with "L", must always be connected
to the live phase.
Electrical Requirements
You can check the parameters of
adjustment setting for this
appliance on the rating plate.
Refer to the Technical data
chapter.
The manufacturer declines any
liability if these safety measures
are not observed.
This hob is designed to be connected to a
220-240 V 50-60 Hz AC electrical supply.
Before switching on, make sure the
electricity supply voltage is the same as that

Gas connection

Warning! Refer to Safety
chapters.
Caution! Information for
authorised installer only.
indicated on the hob rating plate. The rating
plate is located below the surface of the
casing.
The hob is supplied with a 3 core flexible
supply cord.
Upon completion there must be no cut, or
stray strands of wire present and the cord
clamp must be secure over the outer sheath.
Replacement of the connection cable
Warning! To replace the
connection cable, the technician
must have a specific equipment.
In this case, only cable type H03V2V2-F T90
must be used. The cable section must be
suitable to the voltage and the working
temperature. The yellow and green earth
2
wire
must be approximately 2 cm longer
than the brown or black phase wire
Connection to main pipe
Warning! This appliance is not
connected to a combustion
products evacuation device.
16
1
.
1
2