IKEA IH4302SS0 Installation Instructions And Use & Care Manual - Page 7

Browse online or download pdf Installation Instructions And Use & Care Manual for Ventilation Hood IKEA IH4302SS0. IKEA IH4302SS0 28 pages. 30"(76.2cm) wall-mount canopy range hood

Print Page
7. Tape template in place, aligning the template centerline and
bottom of template with hood bottom line and with the
centerline marked on the wall.
<
==
!
!
............. A
! .......
!
|
//Q .....
0 \,
/,
B
B
sI
/
s_
A. Centerline
B. Upper screw locations
C
\
\
\
D
C. Lower screw locations
D. Mounting
height reference
8=
Mark centers of the 4 screw locations through the template to
the wall.
IMPORTANT: All of the screws must be installed into wood.
Remove the template.
9. Drill %4" (2.75 mm) pilot holes at all locations where screws
are being installed into wood.
10. Determine and make all necessary cuts in the wall for the vent
system. Install the vent system before installing the hood. See
"Venting Requirements" section.
11. Determine the required height for the 1/2"conduit and drill a
11¼"(3.2 cm) hole at this location.
12. Run the 1/2"conduit through the hole. Run wire through the
1/2"conduit according to the National Electrical Code or CSA
Standards and local codes and ordinances. There must be
enough 1/2"conduit and wires from the fused disconnect
(or
circuit breaker) box to make the connection in the hood's
electrical terminal box.
13. Use caulk to seal all openings.
NOTE: Do not reconnect power until installation is complete.
14. Insert 2 - 5 x 35 mm screws at the upper screw locations, but
do not completely tighten them. Leave a clearance from the
wall of about 1/2"( 1.3 cm) for hanging the hood.
B
A
3=
4.
Drill 3/8"(9.5 mm) holes for wall anchors and insert anchors
flush with the wall.
Attach vent cover bracket to wall using 2 - 10 x 60 mm
drywall anchors and 2 - 6 x 70 mm screws.
A. Centerline on wall
B. 10 x 60 mm drywall anchors
C. Ventcover bracket
D. 6 x 70 mm screws
nsc
B c ng® looc
Excessive Weight Hazard
Use two or more people to move and install
range hood.
Failure to do so can result in back or other injury.
1. Tip range hood back and remove metal filters.
2. Using 2 or more people, hang range hood on the 2 previously
installed mounting screws through the keyholes in the back of
the range hood.
3. Level the range hood using a level across the bottom of the
hood.
A. 5 x 35 mm mounting screws
B. Centerline on wall
Vent Cover Bracket Installation
Installations using telescoping
upper and lower vent cover
assembly:
1. Position vent cover bracket on wall about 1/8"(3 mm) away
from the ceiling.
2. Mark the hole locations.
4=
A. Mounting screws in upper screw locations
B. Keyhole
C. Mounting screws in lower screw locations
D. Centerline on wall
Secure range hood with 2 mounting screws (C) through
remaining 2 holes in the hood and into the lower screw
locations.