IKEA IH4302SS0 Instruções de instalação e manual de utilização e cuidados - Página 7

Procurar online ou descarregar pdf Instruções de instalação e manual de utilização e cuidados para Campânula de ventilação IKEA IH4302SS0. IKEA IH4302SS0 28 páginas. 30"(76.2cm) wall-mount canopy range hood

Imprimir página

7. Tape template in place, aligning the template centerline and

bottom of template with hood bottom line and with the

centerline marked on the wall.

............. A

! .......

//Q .....

0 \,

A. Centerline

B. Upper screw locations

C. Lower screw locations

D. Mounting

height reference

Mark centers of the 4 screw locations through the template to

the wall.

IMPORTANT: All of the screws must be installed into wood.

Remove the template.

9. Drill %4" (2.75 mm) pilot holes at all locations where screws

are being installed into wood.

10. Determine and make all necessary cuts in the wall for the vent

system. Install the vent system before installing the hood. See

"Venting Requirements" section.

11. Determine the required height for the 1/2"conduit and drill a

11¼"(3.2 cm) hole at this location.

12. Run the 1/2"conduit through the hole. Run wire through the

1/2"conduit according to the National Electrical Code or CSA

Standards and local codes and ordinances. There must be

enough 1/2"conduit and wires from the fused disconnect

(or

circuit breaker) box to make the connection in the hood's

electrical terminal box.

13. Use caulk to seal all openings.

NOTE: Do not reconnect power until installation is complete.

14. Insert 2 - 5 x 35 mm screws at the upper screw locations, but

do not completely tighten them. Leave a clearance from the

wall of about 1/2"( 1.3 cm) for hanging the hood.

Drill 3/8"(9.5 mm) holes for wall anchors and insert anchors

flush with the wall.

Attach vent cover bracket to wall using 2 - 10 x 60 mm

drywall anchors and 2 - 6 x 70 mm screws.

A. Centerline on wall

B. 10 x 60 mm drywall anchors

C. Ventcover bracket

D. 6 x 70 mm screws

nsc

B c ng® looc

Excessive Weight Hazard

Use two or more people to move and install

range hood.

Failure to do so can result in back or other injury.

1. Tip range hood back and remove metal filters.

2. Using 2 or more people, hang range hood on the 2 previously

installed mounting screws through the keyholes in the back of

the range hood.

3. Level the range hood using a level across the bottom of the

hood.

A. 5 x 35 mm mounting screws

B. Centerline on wall

Vent Cover Bracket Installation

Installations using telescoping

upper and lower vent cover

assembly:

1. Position vent cover bracket on wall about 1/8"(3 mm) away

from the ceiling.

2. Mark the hole locations.

A. Mounting screws in upper screw locations

B. Keyhole

C. Mounting screws in lower screw locations

D. Centerline on wall

Secure range hood with 2 mounting screws (C) through

remaining 2 holes in the hood and into the lower screw

locations.