IKEA IH5303WS0 Installation Instructions And Use & Care Manual - Page 7

Browse online or download pdf Installation Instructions And Use & Care Manual for Ventilation Hood IKEA IH5303WS0. IKEA IH5303WS0 28 pages. 90 cm (35 2/5") wall-mount canopy range hood

Print Page

INSTALLATION INSTRUCTIONS

m?scscc ton

It is recommended

that the vent system be installed before

7. Tape template in place, aligning the template centerline and

hood is installed,

bottom of template with hood bottom line and with the

centerline marked on the wall.

Do not cut a joist or stud unless absolutely necessary. If a

joist or stud must be cut, then a supporting

frame must be

constructed.

_==

....

•

Before making cutouts, make sure there is proper clearance

within the ceiling or wall for exhaust vent.

•

Check your ceiling height and the hood height maximum

before you select your hood.

Excessive

Weight Hazard

Use two or more people to move and install range.

Failure to do so can result in back or other injury.

1. If possible, disconnect

and move freestanding

or slide-in

range from cabinet opening to provide easier access to rear

wall. Otherwise, put a thick, protective covering over

countertop,

cooktop or range to protect from damage or dirt.

2. Determine which venting method to use: roof, wall, or non-

vented.

3. Select a flat surface for assembling the range hood. Cover

that surface with a protective covering.

Excessive Weight Hazard

Use two or more people to move and install

range hood.

Failure to do so can result in back or other injury.

Using 2 or more people, lift range hood onto protective

covering.

Determine and mark the centerline on the wall where the

canopy hood will be installed.

Select a mounting height between a minimum of

30" (76.2 cm) and a suggested maximum of 36" (91.4 cm),

above the range to the bottom of the hood and mark

reference line on the wall.

NOTE: For installation locations with reduced ceilings

heights, the vent hood may be installed using the upper vent

cover for both vented and non-vented

(recirculating)

installations.

s f

..............................

3 =

A. Centerline

B. Mounting hook location

C. Fastener locations

D. Mounting height reference

Mark centers of the 6 fastener locations through the template

to the wall.

IMPORTANT: All screws must be installed into wood.

Remove the template.

9. Drill %4" (2.75 mm) pilot holes at all locations where screws

are being installed into wood.

10. Determine and make all necessary cuts in the wall for the vent

system. Install the vent system before installing the hood. See

"Venting Requirements"

section.

11. Determine the required height for the 1/2"conduit and drill a

11¼"(3.2 cm) hole at this location.

12. Run wire through the 1/2"conduit according to the National

Electrical Code or CSA Standards and local codes and

ordinances. There must be enough 1/2"conduit and wires from

the fused disconnect

(or circuit breaker) box to make the

connection

in the hood's electrical terminal box.

13. Use caulk to seal all openings.

NOTE: Do not reconnect power until installation is complete.

14. Attach two mounting hooks to the wall at location marked on

the template.

A.....

..........................

i..............................

A. Mounting hooks

B. Centerline on wall