KitchenAid KUDD01SSPA0 Installation Instructions Manual - Page 3
Browse online or download pdf Installation Instructions Manual for Dishwasher KitchenAid KUDD01SSPA0. KitchenAid KUDD01SSPA0 20 pages. Single drawer dishwasher
INSTALLATION REQUIREMENTS
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools
listed here.
Tools needed:
[]
7 mm socket wrench
[]
Utility knife
[]
5 mm socket wrench
[]
Needle-nose pliers
[]
5 mm open end or box end
wrench
[]
Tape measure
[]
Flat-bladed screwdriver
[]
Electric or hand drill
[]
#2 Phillips screwdriver
[]
11/2 '' hole saw
[]
Side cutting pliers
[]
Valve (sized to fit hot water
supply line) with %" male
[]
Pencil
compression fitting
[]
Sandpaper
[]
Protective floor covering
[]
Level
[] Adjustable wrench that
opens to 11/8"(29 mm)
Parts supplied:
Located in drawer:
[]
2 flexible trim pieces (for sides)
[]
Edge protection
[]
Hose clamp, screw type
[]
Washer
[]
Drain hose support
[]
Drain hose connector
[]
Hose clamp, wire type
[]
11,5/8" long, #8 Phillips head wood screws
[]
Moisture protection tape
[]
3, 1" hex head wood screws
[]
3, 9A8" washers
IMPORTANT: Observe all governing codes and ordinances.
Failure to meet codes and ordinances could lead to fire or
electrical shock.
Proper installation is your responsibility:
[]
Contact a qualified installer to ensure that the dishwasher is
installed to meet all electrical and plumbing national and local
codes and ordinances.
[]
Install the dishwasher as specified in these instructions.
[]
Have everything you need to properly install dishwasher.
[]
Protect dishwasher and water lines leading to dishwasher
against freezing. Damage from freezing is not covered by the
warranty.
[]
This dishwasher is manufactured for indoor use only.
[]
Install the dishwasher in a cabinet cutout that is level, will hold
weight up to 104 Ibs. (47 kg), and is in an area suitable for its
size and use.
Product
dimensions
22 Y_6" *
(57 cm)
163/32"
(40.9 cm)
side
attaching --_
tabs
(52 cm)
drawer open
If custom wood panels are to be used, the product depth is specified
with an
_V_e"(18 mm) door panel thickness.
NOTE: Product shown with front panels for dimension purposes.
Greatest length from product exit point to hookup (does not
include allowance for drain loop):
[]
Drain hose 88 %8" (2250 mm): Extension kit available - part
no. 8194400
[]
Inlet hose 68 7/8" (1750 mm)
[]
Power cord 44" (1125 mm)