KitchenAid KUDD01SSPA0 Handleiding voor installatie-instructies - Pagina 3

Blader online of download pdf Handleiding voor installatie-instructies voor {categorie_naam} KitchenAid KUDD01SSPA0. KitchenAid KUDD01SSPA0 20 pagina's. Single drawer dishwasher

KitchenAid KUDD01SSPA0 Handleiding voor installatie-instructies
INSTALLATION REQUIREMENTS
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools
listed here.
Tools needed:
[]
7 mm socket wrench
[]
Utility knife
[]
5 mm socket wrench
[]
Needle-nose pliers
[]
5 mm open end or box end
wrench
[]
Tape measure
[]
Flat-bladed screwdriver
[]
Electric or hand drill
[]
#2 Phillips screwdriver
[]
11/2 '' hole saw
[]
Side cutting pliers
[]
Valve (sized to fit hot water
supply line) with %" male
[]
Pencil
compression fitting
[]
Sandpaper
[]
Protective floor covering
[]
Level
[] Adjustable wrench that
opens to 11/8"(29 mm)
Parts supplied:
Located in drawer:
[]
2 flexible trim pieces (for sides)
[]
Edge protection
[]
Hose clamp, screw type
[]
Washer
[]
Drain hose support
[]
Drain hose connector
[]
Hose clamp, wire type
[]
11,5/8" long, #8 Phillips head wood screws
[]
Moisture protection tape
[]
3, 1" hex head wood screws
[]
3, 9A8" washers
IMPORTANT: Observe all governing codes and ordinances.
Failure to meet codes and ordinances could lead to fire or
electrical shock.
Proper installation is your responsibility:
[]
Contact a qualified installer to ensure that the dishwasher is
installed to meet all electrical and plumbing national and local
codes and ordinances.
[]
Install the dishwasher as specified in these instructions.
[]
Have everything you need to properly install dishwasher.
[]
Protect dishwasher and water lines leading to dishwasher
against freezing. Damage from freezing is not covered by the
warranty.
[]
This dishwasher is manufactured for indoor use only.
[]
Install the dishwasher in a cabinet cutout that is level, will hold
weight up to 104 Ibs. (47 kg), and is in an area suitable for its
size and use.
Product
dimensions
22 Y_6" *
(57 cm)
163/32"
(40.9 cm)
side
attaching --_
tabs
(52 cm)
drawer open
If custom wood panels are to be used, the product depth is specified
with an
_V_e"(18 mm) door panel thickness.
NOTE: Product shown with front panels for dimension purposes.
Greatest length from product exit point to hookup (does not
include allowance for drain loop):
[]
Drain hose 88 %8" (2250 mm): Extension kit available - part
no. 8194400
[]
Inlet hose 68 7/8" (1750 mm)
[]
Power cord 44" (1125 mm)