Makita 3620 Instruction Manual - Page 8

Browse online or download pdf Instruction Manual for Power Tool Makita 3620. Makita 3620 13 pages. Router
Also for Makita 3620: Instruction Manual (20 pages), Instruction Manual (17 pages), Instruction Manual (17 pages), Instruction Manual (18 pages)

Print Page

1. Straight guide

2. Guide bar

3. Wing bolt

1. Screw

2. Base plate

3. Templet guide

Straight guide

003259

The straight guide is effectively used for straight cuts when chamfering or

grooving.

To install the straight guide, insert the guide bars into the holes in the tool

003260

base. Adjust the distance between the bit and the straight guide. At the desired

distance, tighten the wing bolts to secure the straight guide in place.

When cutting, move the tool with the straight guide flush with the side of the

workpiece.

If the distance (A) between the side of the workpiece and the cutting position is

003261

too wide for the straight guide, or if the side of the workpiece is not straight, the

straight guide cannot be used. In this case, firmly clamp a straight board to the

workpiece and use it as a guide against the router base. Feed the tool in the

direction of the arrow.

Templet guide (Accessory)

003262

The templet guide provides a sleeve through which the bit passes, allowing

use of the tool with templet patterns.

To install the templet guide, loosen the screws on the tool base, insert the tem-

003263

plet guide and then tighten the screws.