Makita 3706 Instruction Manual - Page 7

Browse online or download pdf Instruction Manual for Power Tool Makita 3706. Makita 3706 10 pages. Cutout tool
Also for Makita 3706: Instruction Manual (14 pages), Parts Manual (2 pages), Instruction Manual (17 pages), Instruction Manual (13 pages), Instruction Manual (12 pages)

Print Page

Note:

When using the bit with 1/4" (6.35 mm) shank diameter, first remove the adapter from the

collet cone, then install the bit as described above.

To remove the bit, follow the installation procedure in reverse.

CAUTION:

not tighten the collet nut without inserting a bit, or the collet cone will break.

OPERATION

CAUTIO N :

Avoid forcing the bit to bend or twist. It may snap.

Before turning the tool on, make sure the bit and collet nut are securely tightened.

Hold the tool secure with the bit pointing in a safe direction not contacting any surface

and slide the switch to the "ON" position. Wait until the tool attains full speed

When starting the multipurpose bit into the

material, hold the tool at approximately a 45

degree angle with the edge of the shoe

base contacting the material.

Carefully bring the tool to

straight position

so the shoe base is in full contact with the

material.

When inserting the drywall guide bit into

the drywall, carefully insert the bit straight

until the shoe base is in full contact with the

material.

Move the tool slowly with a constant pres-

sure in a clockwise direction to make the

cut.