Makita 3706 Kullanım Kılavuzu - Sayfa 7

Elektrikli Alet Makita 3706 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Makita 3706 10 sayfaları. Cutout tool
Ayrıca Makita 3706 için: Kullanım Kılavuzu (14 sayfalar), Parça Kılavuzu (2 sayfalar), Kullanım Kılavuzu (17 sayfalar), Kullanım Kılavuzu (13 sayfalar), Kullanım Kılavuzu (12 sayfalar)

Note:

When using the bit with 1/4" (6.35 mm) shank diameter, first remove the adapter from the

collet cone, then install the bit as described above.

To remove the bit, follow the installation procedure in reverse.

CAUTION:

not tighten the collet nut without inserting a bit, or the collet cone will break.

OPERATION

CAUTIO N :

Avoid forcing the bit to bend or twist. It may snap.

Before turning the tool on, make sure the bit and collet nut are securely tightened.

Hold the tool secure with the bit pointing in a safe direction not contacting any surface

and slide the switch to the "ON" position. Wait until the tool attains full speed

When starting the multipurpose bit into the

material, hold the tool at approximately a 45

degree angle with the edge of the shoe

base contacting the material.

Carefully bring the tool to

straight position

so the shoe base is in full contact with the

material.

When inserting the drywall guide bit into

the drywall, carefully insert the bit straight

until the shoe base is in full contact with the

material.

Move the tool slowly with a constant pres-

sure in a clockwise direction to make the

cut.