CORNING LSE 6710 Instruction Manual - Page 4

Browse online or download pdf Instruction Manual for Laboratory Equipment CORNING LSE 6710. CORNING LSE 6710 9 pages. Digital vortexer
Also for CORNING LSE 6710: Instruction Manual (12 pages)

Print Page

3.4 Environmental Requirements

The Corning® LSE™ Multipurpose Digital Vortexer has been built for operating in both

cold and heated laboratory environments and in high humidity environments as follows:

At temperatures between 0°C and +65°C

◗ ◗

In humidity up to 85% (without condensation)

◗ ◗

4.0 Installation of Vortexer Platforms

Cat. No.

Platform Descriptions

48010

Platform for 4 microplates

48011

Platform with non-slip rubber mat

48012

Spring loaded platform for flasks, bottles, or tube racks

The Corning LSE Multipurpose Digital Vortexer requires the installation of the selected

platform. Please follow the instructions below for installing the platform.

Sliding Stabilizers

Before you attach the platform, make sure that the slide stabilizers are properly

fastened, adjusted, and lubricated with the included grease.

The flat mat platform has a circle cut-out in the rubber and screw holes in the center.

Remove the cut-out rubber circle and screw down the 4 screws onto the Vortexer. After

attaching the platform, remove the non-adhesive backing paper on the rubber circle,

and paste it back into place.

The grease is used to lubricate the slide stabilizers. It is sufficient for 1,000 working

hours (approx. 1 year). After that time you should remove the platform and clean,

adjust, and re-grease the slide stabilizers. If they are worn out, you should replace them

with new stabilizers and set to appropriate height.

C ORNING LS E MU LTI PU R PO S E D I G I TA L VO RTEXER

Grease

5.0 Operating Instructions

5.1 Introduction

Run

Time

Power

Speed (RPMx10) time (min)

1. POWER switch– switches Vortexer ON (light on) or OFF.

2. RUN green signal light – lit when the Vortexer is running.

3. TIME yellow signal light – lit when the Vortexer is set on time.

4. RPM yellow signal light – lit when the Vortexer is set on rpm.

5. ENCODER – by rotating the encoder right (+) or left (-) you can change the set TIME or

RPM. Push the encoder to switch between TIME and RPM set values. If you rotate the

ENCODER knob fast, the values go up or down on the display very quickly.

6. START/STOP button – press to START or STOP operation.

5.2 Basic Operation

Run

Time

Power

Speed (RPMx10) time (min)

Press the POWER switch on the control panel. The Vortexer automatically detects

◗ ◗

supply frequency of 50 or 60Hz, and displays F50 or F60. Then the display switches to

show the set TIME and illuminates the TIME light.

Speed

Start

ENCODER

Stop

PUSH

(Time/Speed)