CORNING LSE 6710 Instruction Manual - Page 5

Browse online or download pdf Instruction Manual for Laboratory Equipment CORNING LSE 6710. CORNING LSE 6710 9 pages. Digital vortexer
Also for CORNING LSE 6710: Instruction Manual (12 pages)

Print Page
Run
Time
Power
Speed (RPMx10) time (min)
TIME signal light is on. By rotating the encoder right (+) or left (-) the set time can be
◗ ◗
selected from 30 seconds to 99 minutes 50 seconds:
• 99.5 = 99 minutes 50 seconds
• 9.59 = 9 minutes 59 seconds
• 0.30 = 30 seconds
Run
Time
Power
Speed (RPMx10) time (min)
If you want to set the timer to hold – turn the knob left or right until HLd is displayed.
◗ ◗
You can reach the HLd function by setting to under 0.30 or above 99.5.
Push down on the encoder knob to switch modes between TIME set mode and RPM set
◗ ◗
mode.
8
C ORNING LS E MU LTI PU R PO S E D I G I TA L VO RTEXER
Speed
Start
ENCODER
Stop
PUSH
(Time/Speed)
Speed
Start
ENCODER
Stop
PUSH
(Time/Speed)
Run
Time
Power
Speed (RPMx10) time (min)
RPM signal light is on. By rotating the encoder right (+) or left (-) the desired RPM can
◗ ◗
be selected:
• 34 = 340 rpm
• 120 = 1,200 rpm
Press the START/STOP button to start operation.
◗ ◗
Run
Time
Power
Speed (RPMx10) time (min)
RUN and TIME signal lights are on. The Vortexer runs and counts down the time from
◗ ◗
the set value.
NOTE: You cannot modify the set time during vortexing; however, you can stop the
unit with the START/STOP button and then reset the time.
Speed
Start
ENCODER
Stop
PUSH
(Time/Speed)
Speed
Start
ENCODER
Stop
PUSH
(Time/Speed)
Instruction Manual
9