GardaWorld 2GIG-CP21-345E2 Quick Setup Manual - Page 4
Browse online or download pdf Quick Setup Manual for Security System GardaWorld 2GIG-CP21-345E2. GardaWorld 2GIG-CP21-345E2 5 pages. Diy alarm system
Print PageThin Door/Window Contact
The Thin Door/Window Contact (2GIG‐DW10‐345) is
designed for use on doors, windows, and other
objects that open and close. When the magnet
(which is mounted near the sensor) moves away
from or closer to the door contact's sensor, signals
are transmitted to the control panel. For added
protection, it is also equipped with a cover tamper.
Figure 1 Thin Door/Window Contact
A. Thin Door/Window Contact Sensor
B. Thin Door/Window Contact Magnet
C. Alignment Marks on Sensor
D. Alignment Arrow on Magnet
Box Contents
Verify that the package includes the following:
•
1—Thin Door/Window Contact
•
1—Rare Earth Magnet
•
2—Phillips Head Screws
•
2—Lithium Coin Batteries
•
2—Adhesive Foam Tape
•
1—12 in (30 cm) Wire Lead
Mount Sensors within 100 ft (30 m) of the Control
Panel.
Keep Sensors and Magnets Away from
Metal/Metallic Surfaces. You should also avoid
mounting sensors in areas where there is a large
quantity of metal or electrical wiring (for example,
near a furnace or in a utility room).
Align Magnet with Sensor. Make sure the
alignment arrow on the magnet points to the center
alignment mark on the sensor (see Figure 1 Thin
Door/Window Contact—Sensor and Magnet).
Mounting the Thin Door/Window Contact
Use the figure below as a guideline when mounting
the door contact.
Figure 2 Thin Door/Window Contact
A. Access hole for external input wire (on
backplate)
B. Top and bottom mounting holes (on
backplate)
C. External input wire jack (on sensor)
D. Tamper switch (on sensor)
E. 3‐Volt (3V) lithium coin battery
compartments (on sensor)
F. Metal clips for removing batteries (on
sensor)