GardaWorld 2GIG-CP21-345E2 Quick Setup Manual - Page 5

Browse online or download pdf Quick Setup Manual for Security System GardaWorld 2GIG-CP21-345E2. GardaWorld 2GIG-CP21-345E2 5 pages. Diy alarm system

Print Page

Motion Detector

The Passive Infrared Motion Detector (2GIG‐PIR1‐
345) is a wall-mounted unit with wide‐angle motion
protection. When set to High (HI) Sensitivity Mode,
the PIR has a maximum range of 30 ft deep x 50 ft
wide (9.1 m x 15.2 m). The PIR's pet‐immune
feature can be set to tolerate animals up 55 lbs (25
kg).
Figure 1 Passive Infrared Motion Detector
Box Contents
Verify that the package includes the following:
•
1—Passive Infrared Motion Detector (Part
A)
•
1—Plastic Mounting Bracket (Part B)
•
1—Plastic Wall Mount (Part C)
•
1—Plastic Corner Mount (Part D)
•
2—Plastic Wall Anchors With Screws (not
pictured)
•
1—Short Phillips Head Screw with Fender
(not pictured)
•
1—Short Phillips Head Screw (not pictured)
•
1—Lithium Coin Battery (not pictured)
Inserting and Replacing the Battery
To insert or replace the battery:
•
Unwrap the PIR and remove the screw from
the case bottom.
•
Remove the backplate using a bottom‐to‐top
lifting motion.
•
Insert the battery. Always match the plus (+)
sign on the battery with the flat side of the
compartment and the minus (‐) sign on the
battery with the spring side.
•
4 Replace the PIR cover.
Configuring the PIR Features
Ensure that you have inserted the PIR battery as
described in Inserting and Replacing the Battery.
Then configure the features as follows:
Figure 2 PIR Pet Immune and Sensitivity Features
Step 1: Setting the Pet Immune Feature. To set the
pet immune feature to an appropriate weight:
•
Gently pull out the jumper and slip it over the
desired pins to set one of the pet‐immune
tolerance settings:
o
33 LBS. Tolerates pets up to 33 lbs
(15 kg). OR
o
55 LBS (Default). Tolerates pets up
to 55 lbs (25 kg).
•
Continue with the next step below.
Step 2: Setting the Sensitivity Feature. Gently pull
out the jumper and slip it over the desired pins to set
the desired sensitivity mode:
o
LOW (Default). Low sensitivity. This
is the recommended setting for pets.
OR
o
HIGH. High sensitivity.
NOTE: Do not aim the PIR at stairs, furniture, or
other surfaces that a pet may climb on. The PIR
provides immunity when the room temperature is
above 50° F (10° C) and below 90° F (32° C).