Gardebruk MZ-KS110 Manual - Page 10

Browse online or download pdf Manual for Power Tool Gardebruk MZ-KS110. Gardebruk MZ-KS110 20 pages.

Print Page

II. Technical Data :

Motor

Power

No load speed

Wheel capacity

Weight

Protection class

Note:

and may be used for comparing one tool with another;

Warning:

depending on the ways in which the tool is used;

Intended Use

This machine is only used for regrinding or resharpening of the cutting plate of normal saw chains. Designed

for use on handheld chainsaws are meant for. The regrinding may only be carried out by means of dry

grinding. The required tooth roof sharpening angle, the corresponding tooth roof cutting angle as well as the

required depth limiter distance have to be determined as a function of the the type of saw chain or manufac-

turer. These data can be obtained either from your technical documentation of the chainsaw or from your

specialist dealer.

Only original or approved spare parts may be used. If other spare parts or non-approved components are

used on the machine, the user, not the manufacturer, is liable for personal injury. If the machine is used in

accordance with its intended purpose, this user manual must also be read before each use and adhered to

when using the machine.

www.DeubaXXL.de

230V~, 50Hz

90W (3 s unter Belastung, 8 s ohne Belastung)

5000 min-1

Φ 105mm / Φ 104mm

80,4 dB(A)

93,4 dB(A)

3,574 m/s2

2,3 kg

www.Deuba24online.de

Non-approved use

1 The tool can only be used to sharpen the saw

chain. Never use other material for other urposes

such as grinding and cutting.

2. Clamp the chain before sharpening. For recise

sharpening, avoid the to clamp and break oﬀ the

grinding wheel.

3. Operate evenly during sharpening; sudden

operation may cause clamping of the grinding

wheel or other accidents.

Residual risks

This machine is constructed according to the valid

and applicable directives and standards.

- However, the following residual risks may occur

during use:

- Cutting the ﬁngers on the saw chain (wear

protective gloves)

- contact with the sanding sheet (wear protective

gloves)

- inhalation of sanding dust (wear dust mask)

- Contact with electrical current (supply line

defective, housing defective)

III.ASSEMBLY AND ADJUSTMENTS

PRE-ASSEMBLY

To reduce the packing size, the inside structure of

the sharpener has been improved. Note when the

machine is taken out from the packing. Adjust the

spring to right place ﬁrstly. Do as following

Unfolding the machine, you can see below

structure. Spring status from packing(Fig 1)

Fig 1

www.Deuba24online.de

Move this spring to right slots from both two

Fig 2

Note: this job there is no need to rely on any tool.

If you use some tool, there is much help for your

work.

ASSEMBLY

1. When installing the sharpener on a workbench,

make sure that the Lock Wheel(#18).is accessible,

2. Bolt(bolts not included) the unit directly to the

workbench through the two 1/4" holes on the

base(#17). The workbench must have a solid

product the workpiece and assorted tools. See

FIGTURE 4.

Fig 3