Jands Stage 12 Manual - Page 8

Browse online or download pdf Manual for Music Mixer Jands Stage 12. Jands Stage 12 17 pages.

Print Page

Description of Major Parts

General Description of Major Parts

The front panel of the Stage 12/24 lighting control console is divided into

two main areas. The left section consists of the Preset Faders (A), and Flash

Buttons (B), which are used for both direct control and chase assigning. The

right section consists of all mastering controls including the Grab Controls

(C), Chase Controls (D), Preset masters 1and 2 (E), and Flash controls (F).

The rear panel of the Stage 12/24 houses all the input and output

connections for power, control signals, and the configuration DIP switch.

A Preset Faders are used to set up channel levels. The two Preset banks

B Flash Buttons (Channel) are used to momentarily flash on a channel to

C Grab Controls are used to store and playback two (2) independant

D Chase Controls. There are five (5) controls in the Chase section:-

E P1 and P2 Masters. These two faders scale the level of the top (P1) and

F Flash Master Controls. The Flash Master fader is used to set the level

G Power Input consists of a 2.5 mm plugpack power receptacle for

are used to allow the operator to set up the next scene on one Preset

bank while the output from the other Preset bank is sent live to the stage.

the level of the Add/Solo Master. There is a flash button for each chan-

nel when the desk is operating in the normal 2 preset mode. If the con-

sole is set to Wide mode, only the first 12 channels have flash buttons

(24 channels in the case of the Stage 24).

"snapshots" of the Stage 12/24 output.

- Level fader

- Go/Cue button used to activate the chase output

- Rate control fader

- Fwd/Rev direction button

- Assign button used in conjunction with the channel flash buttons to

select which channels will be included in the chase sequence

bottom (P2) preset banks.

of the flash buttons. The Add /Solo switch to the left of this fader sets

the method of operation for the flash buttons.

connection to a suitably rated plugpack. See the appendix for plugpack

details.