Gardena 1481 Operating Instructions Manual - Page 11
Browse online or download pdf Operating Instructions Manual for Water Pump Gardena 1481. Gardena 1481 18 pages. Pressure tank unit electronic plus with dry-running safety
Also for Gardena 1481: Operating Instructions Manual (19 pages)
Print Page
Cleaning the Integrated Filter
Cleaning the Integrated Back-Flow Valve
Always remove the mains plugs before working on the
pump.
Set or leave the switch on RUN.
.
If necessary, close the shut-off device on the inlet side of the
.
pump.
Unscrew the filter lid by turning anti-clockwise.
.
Remove the filter unit by pulling vertically upwards.
.
Hold the container and remove
.
the filter from the bayonet
socket by turning anti-clock-
wise.
Rinse the container under run-
.
ning water and clean the filter
using a soft brush, for example.
Reassemble the container-
.
filter unit in reverse order.
Insert the cleaned filter unit
.
into the pump.
Screw on the filter lid until tight.
.
Always remove the mains plugs
before working on the pump.
Set or leave the switch on RUN.
.
Ensure that the delivery side is de-
.
A
pressurised, for example, by opening
the consumers.
Close any shut-off devices on the inlet and
.
delivery side.
Loosen the screw by turning it anti-clockwise
.
until you can push the holder upwards and
backwards into opening position.
Remove the lid of the integrated back-flow valve by turning
.
anti-clockwise.
Remove the valve body and rinse under clean running water.
.
After cleaning, replace the valve body centrally in the correct
.
position (cone point downwards).
Screw on the lid until tight.
.
Push the holder forwards and position it in its original position.
.
Then tighten the screw again by turning it clockwise.
23