Garmin GTS 8000 Replacing - Page 4

Browse online or download pdf Replacing for Avionics Display Garmin GTS 8000. Garmin GTS 8000 16 pages. For citation m2, garmin g3000 software version 10
Also for Garmin GTS 8000: Pilot's Manual (26 pages)

Print Page

Section 2 Software and Configuration Loading

This section will provide the steps necessary to target load the software and configuration into

GTS 8000 after replacement.

Note: Anytime that software or configurations are being loaded, all three displays, and both

touch controllers must be in configuration mode.

Note: Ensure that you have completed the steps contained in Section 1.

• GTS 8000

Note that TCAS II functions are through an unlock card. See section 4.

• When the GTS 8000 is replaced, then software and configuration loading is required.

1) Pull the following circuit breakers:

 L PFD

 MFD

 R PFD

 L Touch Control

 R Touch Control

2) Insert the 010-01121-10 software loader card into the upper slot of PFD 1.

3) Turn on aircraft power.

4) Press and hold the right knob on the left GTC and push the L Touch Control circuit

breaker in.

Version 1.0

(TCAS I or TCAS II Processor)