Garmin GHP 10 Owner's Manual - Page 20

Browse online or download pdf Owner's Manual for Marine GPS System Garmin GHP 10. Garmin GHP 10 28 pages. Autopilot system, addendum
Also for Garmin GHP 10: Installation Instructions Manual (48 pages), Installation Instructions Manual (26 pages), Declaration Of Conformity (1 pages), Reference (1 pages), Configuration Notes (14 pages)

Print Page

Settings

settings

You can customize system, remote control, and user settings.

From the heading screen, select Menu > Setup > System.

• Units—set the units of measure used to represent values displayed on the

GHC 10.

◦ System Units—units used for every measurement displayed by the

GHC 10. You can select Statute (mi., ft.), Metric (km, m), Nautical

(nm, ft.), or Metric Nautical (nm, m).

◦ Helm Displacement—unit used for displacement volume of the

hydraulic steering pump, typically indicated on the helm. You can

select Cubic Inches (cu. in.) or Cubic Centimeters (cc).

• Heading—set the reference used in calculating heading information.

◦ Magnetic—calculates the heading based on magnetic north.

◦ True—calculates the heading based on true north.

• Variance—set the variance from true north. Variance is available only

when the Heading is set to True.

◦ Auto—automatically determines the ideal variance setting.

◦ User—you define the variance setting.

• Beeper—set whether the device makes sounds when you select a key or

when an alarm sounds.

◦ Alarms only—beeps only when an alarm sounds.

◦ on (Keys & Alarms)—beeps when you select a key and when an

alarm sounds.

• Auto Power—enables the device to turn on automatically when the

NMEA 2000 network turns on.

• Unit Voltage—the device displays an alert and sounds an alarm when

the battery reaches a specified voltage. When you select On, you must

specify the voltage at which the alarm sounds and the alert displays.

• Language—set the on-screen language.

• operating Mode—set the device to operate normally or in store

demonstration mode.

• System Information—shows the device ID numbers and software

information for the GHC and GHP.

• Factory Defaults—select Reset to restore the device to factory defaults.

Before using the GHC 10 remote, you must connect the remote to the

GHC 10 and configure the settings.

You can connect one GHC 10 remote (optional) to a GHC 10.

1. From the Heading screen, select Menu > Setup > Remote.

2. Select Search for Remote, then hold the left and right double-arrow

keys on the remote. The autopilot to searches for and pairs with the

GHC 10 remote.

GHC 10 Owner's Manual