Fujitsu PRIMERGY TX300 S3 Service Supplement Manual - Page 33
Browse online or download pdf Service Supplement Manual for Server Fujitsu PRIMERGY TX300 S3. Fujitsu PRIMERGY TX300 S3 47 pages.
Print Page
Replacement routines
Replacing the IDTEMP combo
The IDTEMP combo must be correctly installed in order:
– to monitor the temperature correctly,
– to enable the server management to display the correct system picture,
– to install the server using ServerStart.
The IDTEMP combo is mounted between the hard disk cage and the accessible
drives.
Ê Open the server as described in the
section "Preparation" on page
17.
Ê Remove the ventilation duct over the system fans.
Figure 14: Removing the cable clamp
2
Ê Remove the green cable clamp from the connector of the I
C cable.
2
Ê Pull the I
C cable out of the white cable clamps.
2
Ê Remove the I
C cable from the connector on the IDTEMP combo.
Ê Remove the screw and take out the IDTEMP combo.
Ê Insert the new IDTEMP combo and fasten it with one screw.
2
Ê Plug the I
C cable on the connector on the IDTEMP combo.
2
Ê Push the I
C cable into the white cable clamps.
2
Ê Plug the green cable clamp on the connector of the I
C cable.
Ê Reinstall the ventilation duct over the system fans.
Service Supplement
33
TX300 S3