Fujitsu PRIMERGY TX300 S3 Посібник із сервісного доповнення - Сторінка 33

Переглянути онлайн або завантажити pdf Посібник із сервісного доповнення для Сервер Fujitsu PRIMERGY TX300 S3. Fujitsu PRIMERGY TX300 S3 47 сторінок.

Replacement routines

Replacing the IDTEMP combo

The IDTEMP combo must be correctly installed in order:

– to monitor the temperature correctly,

– to enable the server management to display the correct system picture,

– to install the server using ServerStart.

The IDTEMP combo is mounted between the hard disk cage and the accessible

drives.

Ê Open the server as described in the

section "Preparation" on page

17.

Ê Remove the ventilation duct over the system fans.

Figure 14: Removing the cable clamp

Ê Remove the green cable clamp from the connector of the I

C cable.

Ê Pull the I

C cable out of the white cable clamps.

Ê Remove the I

C cable from the connector on the IDTEMP combo.

Ê Remove the screw and take out the IDTEMP combo.

Ê Insert the new IDTEMP combo and fasten it with one screw.

Ê Plug the I

C cable on the connector on the IDTEMP combo.

Ê Push the I

C cable into the white cable clamps.

Ê Plug the green cable clamp on the connector of the I

C cable.

Ê Reinstall the ventilation duct over the system fans.

Service Supplement

TX300 S3