Fujitsu fi-4530C Getting Started - Page 9

Browse online or download pdf Getting Started for Scanner Fujitsu fi-4530C. Fujitsu fi-4530C 27 pages. Image scanner
Also for Fujitsu fi-4530C: Installation Procedures Manual (7 pages), Installation Procedures Manual (9 pages), Brochure & Specs (2 pages), Installation Procedures (3 pages), Consumable Replacement And Cleaning Instructions (14 pages), Cleaning Instructions Manual (13 pages), Cleaning Instructions (2 pages), Instruction Manual (10 pages), Installation Procedure (5 pages)

Print Page
Fujitsu fi-4530C Getting Started
.
Name
Function No. display
But-
Function
tons
Send to
Scan
Power button
LED
-
*) About the settings on the launcher, refer to FUJITSU
TWAIN32 scanner driver help and the "fi-4530C
Operator's Guide" on the Setup CD-ROM.
■ Indications on the Function No.
display
The following shows the indications on the Function
No. display.
8
Blinks only one time upon turning on the scanner.
P
Indicates that the scanner has been turned ON and
is being initialized.
0
Indicates that initialization will soon be completed.
1
Indicates that initialization has been completed
successfully.
This status is called "Ready Status".
U
Indicates that a temporary error (that users can
solve) has occurred during the initialization or
scanning of documents.
"U" and an error number (1, 2, 6) are displayed
alternately.
To return the scanner to the ready status ("1"),
press the "Scan" or "Send to" button while the error
is indicated.
2
Function
Indicates the function No. and
error status.
Changes the Function activated
by the Send to button (*).
Launches the linked application
software (*).
Turns the scanner ON and OFF.
Lights when the scanner is
turned ON.
E
Indicates that a device alarm (that users can not
solve) has occurred during the initialization or
scanning of documents.
"E" and an alarm number (2 to 9, and A, c, d, F) are
indicated alternately.
To return the scanner to the ready status ("1"),
press "Scan" or "Send to" button while the alarm is
indicated.
If this alarm occurs, turn the power off and then on
again. If the alarm is indicated after turning on the
power again, contact your service engineer.