Fujitsu FI-5900C Getting Started - Page 11

Browse online or download pdf Getting Started for Scanner Fujitsu FI-5900C. Fujitsu FI-5900C 30 pages. Consumable replacement and cleaning instructions
Also for Fujitsu FI-5900C: Getting Started (30 pages), Installation Procedures Manual (7 pages), Installation Procedures Manual (9 pages), Installation Procedures (3 pages), Brochure & Specs (2 pages), Supplementary Manual (4 pages), Brochure & Specs (4 pages), Consumable Replacement And Cleaning Instructions (24 pages), Replacement Procedure (22 pages), Cleaning Instructions (2 pages)

Print Page
Fujitsu FI-5900C Getting Started
Name
Use this button to start linked applica-
Scan
tion.
When this button is pressed during
scanning operation, the scanning is
cancelled
(*About the settings, refer to the "fi-
5900C Operator's Guide" on the Setup
CD-ROM).
Use this button to turn the power ON/
OFF.
When the power is turned on, the but-
ton is illuminated in blue.
Operator Panel Overlays are available in
HINT
French, German, Italian, Spanish, and Chi-
nese (Simplified). To change the overlay,
open the plastic cover.
Function
fi-5900C Image Scanner Getting Started
■ Indications on the Function
Number Display
The following shows the indications on the Function
Number Display.
No.
Lights only one time upon turning on the scanner.
Indicates that the scanner has been turned ON
and is being initialized.
Indicates that initialization has been completed
successfully.
This status is called "Ready Status."
Indicates that a temporary error (that users can
solve) has occurred during the initialization or
scanning of documents.
"J" or "U" and an error number (1, 2, 4, 6, 8, 0)
or
are displayed alternately.
To return the scanner to the ready status ("1"),
press the "Scan" or "Send to" button while the
error is indicated.
Indicates that a device alarm (that users can not
solve) has occurred during the initialization or
scanning of documents.
"E" and an alarm number (0, 2 to 9, and A, c, d,
F, 10 to 12, 15 to 19, 1A) are indicated alter-
nately.
To return the scanner to the ready status ("1"),
press the "Scan" or "Send to" button.
If this alarm occurs, turn the power off and then
on again. If the alarm is indicated after turning on
the power again, contact your service engineer.
Descriptions
3