Fujitsu ETERNUS AF250 Setup Manual - Page 4

Browse online or download pdf Setup Manual for Storage Fujitsu ETERNUS AF250. Fujitsu ETERNUS AF250 12 pages. Hybrid storage systems, all-flash arrays, power synchronized unit
Also for Fujitsu ETERNUS AF250: Configuration Manual (18 pages), Safety Precautions (12 pages), Site Planning Manual (38 pages)

Fujitsu ETERNUS AF250 Setup Manual

Cable Connection

STEP
Various cables need to be connected to the ports on the rear of the ETERNUS AF.
Configuration Guide (Basic)
To help with cable management and prevent incorrect connection, attach labels to the cables and make a note
Point
of connection origins and destinations.
IMPORTANT
LAN Cable
1
MNT port
A port that is used to connect to an operation management LAN. Before connecting to the operation
management LAN, change the IP address of the MNT port in the Setup Network Environment settings.
RMT port
A port that is used for initial setup or to connect to the remote support center.
Cable

Host Interface Cable

2
Connect a host interface cable to each host interface port.
Cable
FC,
iSCSI 10Gbit/s (10GBASE-SR)
(for FC cable connection)
iSCSI 10Gbit/s (10GBASE-SR)
(for Copper Twinax cable connection)
iSCSI 10Gbit/s (10GBASE-T)
The cables should never be bent, twisted or pulled.
Some cables have static-sensitive electronic components. Wear an anti-static wrist strap or touch a metal
part to discharge the static electricity on your body before starting each operation. Failure to discharge static
electricity before touching the connectors may cause a device failure.
Rear view
Controller (CM#0)
Rear view
FUJITSU Storage ETERNUS AF250 All-Flash Arrays Setup Guide
Copyright 2017 FUJITSU LIMITED
Controller (CM#1)
RMT port
MNT port
CA#0
CA#1
FC
iSCSI 10Gbit/s (10GBASE-SR)
,
(for FC cable connection)
Port#0
Port#1
iSCSI 10Gbit/s (10GBASE-T)
Port#0
Port#1
4
RMT port
MNT port
CA#0
CA#1
iSCSI 10Gbit/s (10GBASE-SR)
(for Copper Twinax cable connection)
Port#0
Port#1
P3AG-1862-02ENZ0