Fujitsu Eternus DX200F Operation Manual - Page 23

Browse online or download pdf Operation Manual for Storage Fujitsu Eternus DX200F. Fujitsu Eternus DX200F 48 pages. Hybrid storage systems, all-flash arrays, power synchronized unit
Also for Fujitsu Eternus DX200F: Setup Manual (10 pages), Configuration Manual (28 pages), Configuration Manual (13 pages), Configuration Manual (16 pages), Configuration Manual (38 pages), Safety Precautions (12 pages)

Print Page
Fujitsu Eternus DX200F Operation Manual
Chapter 2
Basic Operation
2.2

Using the FUNCTION Button

1
Press and hold the Power switch of the ETERNUS DX for four seconds or more.
Power switch
The READY LED on the ETERNUS DX is turned off.
Press the Power switch only once. If the Power switch is pressed again between the time of the
READY LED turning off and the POWER LED turning off, the ETERNUS DX power may turn on.
2
The ETERNUS DX power is turned off.
The POWER LED of the ETERNUS DX is turned off.
2.2
Using the FUNCTION Button
This section explains how to use the FUNCTION button of the ETERNUS DX.
The following settings can be performed by using the FUNCTION button:
•
Switching the Master CM to the other controller
For the two controllers in the ETERNUS DX, the controller through which the ETERNUS DX is set up and
operated is called the "Master CM", while the other controller is called the "Slave CM".
Restoring the factory default settings (network environment settings and firewall settings) of the LAN ports
•
The following procedure explains how to use the FUNCTION button.
23
FUJITSU Storage ETERNUS DX200F All Flash Array Operation Guide (Basic)
Copyright 2014 FUJITSU LIMITED
P3AM-8472-01ENZ0