- ページ 23

ストレージ Fujitsu Eternus DX200FのPDF 操作マニュアルをオンラインで閲覧またはダウンロードできます。Fujitsu Eternus DX200F 48 ページ。 Hybrid storage systems, all-flash arrays, power synchronized unit
Fujitsu Eternus DX200F にも：セットアップマニュアル (10 ページ), 設定マニュアル (28 ページ), 設定マニュアル (13 ページ), 設定マニュアル (16 ページ), 設定マニュアル (38 ページ), 安全上のご注意 (12 ページ)

Chapter 2

Basic Operation

2.2

Using the FUNCTION Button

Press and hold the Power switch of the ETERNUS DX for four seconds or more.

Power switch

The READY LED on the ETERNUS DX is turned off.

Press the Power switch only once. If the Power switch is pressed again between the time of the

READY LED turning off and the POWER LED turning off, the ETERNUS DX power may turn on.

The ETERNUS DX power is turned off.

The POWER LED of the ETERNUS DX is turned off.

2.2

Using the FUNCTION Button

This section explains how to use the FUNCTION button of the ETERNUS DX.

The following settings can be performed by using the FUNCTION button:

•

Switching the Master CM to the other controller

For the two controllers in the ETERNUS DX, the controller through which the ETERNUS DX is set up and

operated is called the "Master CM", while the other controller is called the "Slave CM".

Restoring the factory default settings (network environment settings and firewall settings) of the LAN ports

•

The following procedure explains how to use the FUNCTION button.

FUJITSU Storage ETERNUS DX200F All Flash Array Operation Guide (Basic)

P3AM-8472-01ENZ0