Fujitsu ETERNUS DX60 S2 User Manual - Page 34

Browse online or download pdf User Manual for Storage Fujitsu ETERNUS DX60 S2. Fujitsu ETERNUS DX60 S2 42 pages. Server connection. (fibre channel) for aix
Also for Fujitsu ETERNUS DX60 S2: User Manual (35 pages), Configuration Manual (28 pages), User Manual (14 pages), Configuration Manual (16 pages), Configuration Manual (38 pages), Hardware And Software Installation Manual (36 pages)

Print Page

Chapter 6

Setting Up the VMware ESX Server

6.2

For VMware Infrastructure 3

6.2.4

Setting the Software Initiator

Enable Software Initiator in VMware ESX.

Select the [Configuration] tab on VMware Infrastructure Client and click [Storage Adapters].

Select the target iSCSI Software Adapter and click [Properties].

Click [Configure] on the [General] tab.

Select the [Status-Enabled] checkbox and click the [OK] button.

Confirm that the [Enabled] checkbox is selected under "Status" on the [General] tab and click [Config-

ure] again.

Confirm that the iSCSI name is displayed as follows and click the [Cancel] button.

Select the [Dynamic Discovery] tab and click the [Add] button.

Enter the IP address for the iSCSI port of the connected ETERNUS DX Disk storage system as the iSCSI

server IP address, confirm that the port is set to "Port 3260" (default), and click the [OK] button.

ETERNUS DX Disk storage systems User's Guide -Server Connection-(iSCSI) for VMware

ESX

P3AM-3412-13ENZ0